Hopefully after you have done all this the computer might possibly work correctly again. You do not want to remove any components from the board. For additional troubleshooting steps, see Keyboard keys may not work. Here is a link that describes the process.Īs always with electronics, especially surface mounted PCBs be gentle when handling and especially when brushing away the corrosion. To be sure this content applies to the device you need information on, please enter your serial number or select your product. If you do check the label to verify the amount of IPA. Do not use "rubbing alcohol" as in some cases this is only 70% IPA or less, can contain scents and is not as effective. Then you need to dis-assemble the rest of the computer and clean all the affected parts using Isopropyl Alcohol 90%+ (available from electronics parts stores) to remove all traces of corrosion and water. The impurities in the water causes corrosion and provides circuit paths for the electricity which were not in the PCs operating design and could damage the components.įirst do not attempt to turn on your computer and then you need to remove the battery as soon as possible from the computer to minimize further damage. As you know water and electronics and electricity are not a good mix.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |